Recall homework
There are 2 official recalls listed for this model year. Before buying, use the VIN to confirm which campaigns are still open and ask for dealer repair records on completed work.
Vehicle report
Recalls, consumer complaints, safety ratings, fuel cost estimate, and next steps from official public data sources.
Buyer interpretation
The useful question is not just whether this page has records. It is what those records should make you verify before money changes hands.
There are 2 official recalls listed for this model year. Before buying, use the VIN to confirm which campaigns are still open and ask for dealer repair records on completed work.
Owner complaints most often mention steering, electrical system, unknown or other. Scan those categories before the test drive so you know what symptoms, warning lights, or service history to ask about.
98 manufacturer communications are listed. These are not recalls, but they can reveal repair instructions, warranty extensions, software notices, or known service patterns.
The fuel-cost estimate is based on a representative EPA match, not every trim. Confirm the actual engine, drivetrain, and tire setup before comparing this listing with another year or model.
Use our buyer checklist to know what to inspect, ask, and verify before the test drive.
Official safety ratings were found for 1 tested variant of the 2022 Nissan Sentra.
2 official recalls on record for the 2022 Nissan Sentra. 15 matched quarterly completion reports are available.
Latest recall: August 15, 2023
| Campaign | Component | Summary | Consequence | Remedy | Date | Completion |
|---|---|---|---|---|---|---|
| 23V581000 | STEERING:LINKAGES:TIE ROD ASSEMBLY | Nissan North America, Inc. (Nissan) is recalling certain 2020-2022 Sentra vehicles. The left and/or right tie rod may bend. | A bent tie rod can break and cause a loss of steering control, increasing the risk of a crash. | Owners are advised to contact their dealer for transport assistance if they are experiencing an off-center steering wheel or vibration. As an interim repair, dealers will inspect and replace any bent or broken tie rods, free of charge. Once newly designed parts are available, dealers will replace both left and right tie rods, free of charge. Owner letters were mailed November 27, 2024. Owners may contact Nissan's customer service at 1-800-867-7669. Nissan's number for this recall is R23B3. This recall replaces and expands recall number 21V-461. Vehicles previously repaired under 21V-461 will need to have the new remedy completed. | Aug 2023 | 2026-1 |
| 23V421000 | STRUCTURE:BODY | Nissan North America, Inc. (Nissan) is recalling certain 2022 Sentra vehicles. The driver's side cowl area may have a missing or improper seal, which can allow water to leak inside the vehicle and corrode electrical components. | Corrosion of the electrical components could result in failure of various electrical systems, such as loss of wiper motor function or exterior lighting, inoperative air bags, or the ability to shift into gear without applying the brake pedal. Any of these scenarios can increase the risk of a crash. In addition, an electrical short-circuit may occur, increasing the risk of a fire. | Dealers will inspect and, if necessary, reseal the driver's side cowl. If moisture or corrosion is found, the main harness and engine room harness will be replaced. Repairs will be performed free of charge. Owner notification letters are expected to be mailed July 26, 2023. Owners may contact Nissan's customer service at 1-800-867-7669. | Jun 2023 | 2025-3 |
Official records show 98 manufacturer communications on record for the 2022 Nissan Sentra.
| Date | Type | Component | Summary | ID / document |
|---|---|---|---|---|
| Apr 2026 | Service Bulletin/Repair Instructions | STRUCTURE:BODY | CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1). | 11031705 |
| Apr 2026 | Service Bulletin/Repair Instructions | STRUCTURE:BODY | CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1). | 11031704 |
| Feb 2025 | Service Bulletin/Repair Instructions | FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING | INTELLIGENT CRUISE CONTROL INOPERATIVE AND AEB/FEB WARNING LIGHT ON OR RADAR OBSTRUCTION MESSAGE DISPLAYED WITH DTC C1A16 OR C2582 IF YOU CONFIRM IMPORTANT: The purpose of ACTION (on the next page) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. The customer states that the ICC stopped working while driving, OR The customer states that the AEB/FEB warning light is ON, or turned ON, while driving (Figure 1), OR The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONLY DTC stored. Figure 1 Figure 2 This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner’s Manual | 11014471 |
| Feb 2025 | Service Bulletin/Repair Instructions | ELECTRICAL SYSTEM | AUTOMATIC EMERGENCY BRAKING WARNING LIGHT BLINKING APPLIED SYSTEMS: Vehicles equipped with a lane camera (see Figure 1) SERVICE INFORMATION If the Automatic Emergency Braking (AEB) warning light or is blinking (but not illuminated steadily) or the customer states it is blinking, and there are no related DTCs, inspect the windshield. A blinking AEB warning light may occur under the following conditions: When contamination or foreign material adhere to the lane camera viewing window on the windshield. When driving while it is snowing or when frost forms on the lane camera viewing window on the windshield. When the lane camera viewing window on the windshield is temporarily fogged up. Figure 1 Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle. HINT: o Refer to the applicable ESM for diagnosis if DTCs are present in the Laser/Radar, ICC/ADAS, or Lane Camera systems. o For further information: Refer to the following pages. Use the search keyword “blinking” in the ESM. | 11014472 |
| Jan 2025 | Service Bulletin/Repair Instructions | ENGINE | SERVICE INFORMATION If one of the APPLIED VEHICLES has DTC P2100 for “ETC MOT PWR-B1” or P2101 for “ETC FNCTN/CIRC-B1” stored in the Engine Control Module (ECM) with a customer complaint of loss of power, Perform the revised Electronic Service Manual (ESM) procedure noted on page 2 for "PERFORM DTC CONFIRMATION PROCEDURE." HINT: This revised procedure will be added to the ESM in a future update. | 11013281 |
| Sep 2024 | Service Bulletin/Repair Instructions | AIR BAGS | DTC B00A0-00 STORED This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored, AND OCS zero point reset cannot be performed, (continued on the next page) | 11009068 |
| Sep 2024 | Service Bulletin/Repair Instructions | ENGINE | ENGINE SUPPORT TOOLS APPLIED VEHICLES: 2020-2024 Sentra (B18) SERVICE INFORMATION A new Engine Support Bracket is now available to allow the CVT to be removed from the APPLIED VEHICLES without having to remove the engine. The procedure in this bulletin is different from the procedure currently in the ESM, which will be updated with this information at a later date. Please refer to the SERVICE PROCEDURE in this bulletin for information on how to use these new tools. | 11007655 |
| Aug 2024 | Service Bulletin/Repair Instructions | STRUCTURE:BODY | RATTLE OR KNOCK NOISE FROM FRONT WHEN DRIVING OVER BUMPS AND/OR TURNING APPLIED VEHICLES: 2021-2024 Sentra (B18) APPLIED DATES: Built from January 2, 2021 to April 11, 2024 IF YOU CONFIRM A rattle or knock noise is heard from the front of the vehicle when driving over bumps and/or turning. HINT: To aid in diagnosis, it is recommended that you view the video clip on ASIST before starting. To view the video full screen, right click the center of the video screen and select “Full Screen”. ACTION Follow the SERVICE PROCEDURE in this bulletin to verify the passenger (RH) side Engine Mounting Insulator is the source of the noise, and replace it with the one listed in the PARTS INFORMATION on the last page. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM A rattle or knock noise is heard from the front of the vehicle when driving over bumps and/or turning. HINT: To aid in diagnosis, it is recommended that you view the video clip on ASIST before starting. To view the video full screen, right click the center of the video screen and select “Full Screen”. ACTION Follow the SERVICE PROCEDURE in this bulletin to verify the passenger (RH) side Engine Mounting Insulator is the source of the noise, and replace it with the one listed in the PARTS INFORMATION on the last page. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. | 11006976 |
| Aug 2024 | Service Bulletin/Repair Instructions | ELECTRICAL SYSTEM | DTC B2E01-96 (INTERNAL BATTERY) STORED AS CURRENT IN IVC This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. SERVICE INFORMATION The APPLIED VEHICLES that come equipped with a factory installed SOS switch, located near the overhead map lamp, also come equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active NissanConnect® Services subscription, the TCU communicates with the Nissan Data Center to provide various security and convenience services. CONSULT has been updated to allow DTC B2E01-96 for “Internal battery” to be cleared in the TCU. If DTC B2E01-96 is Current/Active in the TCU, and no additional Current/Active DTCs are present in the TCU, perform the SERVICE PROCEDURE starting on page 2. | 11006973 |
| Aug 2024 | Service Bulletin/Repair Instructions | ELECTRICAL SYSTEM | DTCS B2E4B-06, B2E60-06, B2E61-06 DISPLAYED AS CRNT IN THE TCU This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. IF YOU CONFIRM The customer experiences an issue with the NissanConnect® Service remote commands, AND Any of the following DTCs are displayed as CRNT in the Telematics Control Unit (TCU): B2E4B-06 B2E60-06 B2E61-06 HINT: These DTCs are caused by an issue with a cloud-server that is related to the TCU. ACTION 1. Do NOT replace the TCU. Replacing the TCU will not resolve the concern. 2. Send an email to NTB21-037@Nissan-Usa.com. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair. | 11006972 |
78 total complaints on record
Assumptions: 29 city / 39 highway / 33 combined MPG · Regular Gasoline · efficiency ratings from official public data when available · fuel price default: official public data (U.S. average, Jun 3, 2026)